These bushings replace your old rear Lower Control Arm inner bushings with a Superpro Polyurethane Bushing that are built to last. Featuring Duralloy bearing cups. 

The mount is offset to allow +/-0.6 degrees of camber adjustment. roughly enough for correcting a 1-1.25" drop.

Set includes 2-Bushing sets for to replace both bushings

Press-Fit into existing control arm

includes grease

Install:

Remove old bushing carefully as you do not want to collapse the stock control arm sheetmetal.  You can use a stack of thick washers to prevent this.

Once stock bushings is removed, press in these new bushings with care and use the same method to support the two sheetmetal surfaces so they do not collapse.  

We suggest a cut piece of tube or steel plate section bent in a u-shape.

You're done!

 Also works on IS200, RS200 and RHD chassis if out of stock perorder and allow 4 weeks to get them.

Part of our Rear MASTER BUSHING SET for the IS300