Now offering an OE style replacement bearing for where the lower control arm connects to the knuckle.

Set includes 2-Bearings to cover both sides of the vehicle.

A bearing service tool (large C clamp) with cups for both sides is suggested since the bearing will need to overtravel to be centered in the knuckle. 

Install:  Covered in our blog.

Remove old bearing via any means possible. A heavy bearing service tool is suggested.

Press in bearing cup/bearing assembly*, these are direction and have a lead in section on one end

*NOTE only press on the outer cup section, never the bearing center. For easier installation freeze the bearing and heat the knuckle slighlty with a heatgun or torch.

Install stainless steel misalignment spacers

Inspect to make sure there is no binding in the bearing motion. If low speed stiction is present, lubricate the bearing with a DRY FILM teflon spray.