REAR SWAY BAR ENDLINKS

Version: 2.0 - upgraded rod ends and press in stud on mount end.

ROD END TYPE: 3-P FK Rod ends, Teflon lined, Precision series.

Includes a pair of endlinks

FEATURES:

• Allows preload adjustment when lowered or with aftermarket sway bars.
• Replaces bent or loose factory endlinks from lowered vehicles
• Shorter than stock endlinks

INSTALL NOTE:

• Measure the endlink length to make the sway bar pickup point flat with its bushing (0 preload) when the vehicle is loaded.
• Adjust the linkage to that length and mount, setting the jam nut.
• The stud is press fit to the rod end and has 2 flats on it. The 2 nylon washers are intended to be preloaded but do not over-tighten.  We suggest 24ft-lbs or a 1/4 turn past fully mated.