Ask Question
This is an upgraded version of our standard bushing and features a stiffer 90 durometer Poly. Watch the video to see how they perform under pressure. These bushings replace the staked factory rubber bushings with Superpro Polyurethane Bushings that are built to last and properly engineering to increase performance. The high-end polyurethane design eliminates the parasitic spring rate caused by staked bushings and increase service life. These bushings also provide more positive front arm location during spirited driving. It also will reduce inner tire wear due to toe deflection under braking
The set has Two Offset bushings to correct pulling to one side and or crossmember misalignment or to correct caster angle. You will need to determine which way the correction will need to go prior and during installation which may require additional alignment time.
Set includes 2-Bushing sets to replace both bushings
includes grease
a shop press is strongly suggested for ease of install. Its pretty much manditory don't try to do this without one.
3" thinwall aluminum tubing can be uses as a press collar.
Video of it in action
Install:
The bushing sits at the back of the front LCA which is held on by two bolts into the chassis and one bolt through that is an extension of the arm.
You will need to remove both undercovers and the side bracket bolt that is attached to the #2 bushing bracket.
Remove the two bolts holding the bearing bracket (one with nut) and 2 side rail bracket
Remove the rear nut that holds the bracket to the LCA.
Remove rear bushing bracket, this may require deflection of the front arm bushing. If too difficult you will need to remove the entire arm, sway bar and shock absorber. Contact FIGS is this is the case.
With a shop press, remove the old bushing.
Press the new bushing into the aluminum retaining bracket. Keep in mind that you will press in to correct the alignment condition and offset the rear mount. Use this to adjust the caster angle when out of spec. This may require iteration since the bearing presses in. Its best to spot check the alignmet while determining the location of the offset. For uniform caster angle you will need to look at the alignment sheet. mount goes out to increase and inward to decrease.
Reinstall rear nut to hold bushing in place but not to final torque.
Reinstall 2 bolts plus nut and 2 bolts of side bracket. Long bolt through side rail bracket Torque to 204Nm/ 150ft-lbs, short bolt with nut 86Nm/63ft-lbs side rail bolts 50Nm/37ft-lbs
verify clean cyling with suspension by loading and unloading. While suspension is loaded, apply final torque to through post nut. Torque to 113Nm/ 83ft-lbs
You done!
GEN 2IS ISX50 IS-F 3GS FRONT LOWER ARM REAR MOUNT #2 POLYURETHANE BUSHING DOUBLE OFFSET 90 HIGH PERFORMANCE
- Brand: SuperPro
- Product Code: A270
- Availability: In Stock
- $211.10
-
$189.99
Related Products
Tags: SPF3692-90K, Gen, 2IS, ISx50, IS-F, 3GS, Front, Lower, Arm, Rear, Mount, #2, Polyurethane, Bushing, Double, Offset, 90, HIGH, PERFORMANCE, 3692, 3692-90