FRONT SWAY BAR ENDLINKS

Application 2006-2013 IS250,IS350, IS-F, 2007-2012 GS350, GS460.

Version: 2.0 - upgraded rod ends and press in stud on mount end.

ROD END TYPE: 3-P FK Rod ends, Teflon lined, Precision series.

Includes a pair of endlinks

For RWD cars. See our listing if you need a set for AWD.
 

FEATURES:

-Allows preload adjustment when lowered or with aftermarket sway bars.

-Replaces bent or loose factory endlinks from lowered vehicles

-Speeds up sway bar response.

-In their shortest length, they are slightly shorter than stock, but adjustable to eliminate sway bar preload.

INSTALL NOTES:

-Do not exceed 30 ft-lbs of torque on the sway mount nut (DIRECT CONNECTION TO THE SWAY BAR). Do this by holding onto the flats on the stud, not the safety screw on the rod end. The flats are on the same side as the washers in the assembly stack. This is a 14mm flat spacing

-Do not torque the lower nut; this is only to attach the rod end. We torque this as part of the assembly process. You will only need to torque the lower M12 flange bolt and use the flats on the fitting on the opposite side of the flange, the parts that contact the arm. This is a 17mm head bolt, and the flat spacing is standard , an adjustable wrench is suggested. A 15mm wrench may fit, depending on the wrench manufacturer.