These bushings replace the staked rear inner rubber bushings on the upper control arm with high quality 95A polyurethane lubricated bushings that will not impact spring rate.  An Eccentric Adjustable Version is also available to fine tune camber and wheel placement.  Note that the rear subframe should be lowered for the install of these bushings.

Set includes 8-Bushings and 4-tubes to replace both bushings on each of the rear upper arms, as well as installation grease. Also includes Aluminum Shims for Alloy Arms, if you don't need the aluminum shims just order these bushings.

A shop press is strongly suggested for ease of install. 

Install:

• Lower rear sub frame to get access to the UCA bolts
• Remove UCA and outer upper ball joint (easier said then done ;) )  Using a ball joint removal tool. We recommend this one found on Amazon.
• Remove old bushing via any means possible.
• Lube new poly bushing and press in first, fill voids and coat the lead in transition.
• Press in cylinder shaft second and determine which orientation you would like to add or subtract camber.
• Reinstall the UCA and the rear sub frame torqueing to factory specs.
• You're done!