A BEST SELLER!!
PREORDER

Ask Question

A BEST SELLER!

This is an upgraded version of our standard bushing and features a stiffer 90 durometer proprietary polyurethane material pre-installed into the factory aluminum bracket.  With so much demand for these bushings, we are making it that much easier to upgrade. Watch the video to see how they perform under pressure.  These bushings replace the staked factory rubber bushings with Superpro Polyurethane Bushings that are built to last and properly engineering to increase performance.  The high-end polyurethane design eliminates the parasitic spring rate caused by staked bushings and increases service life. These bushings also provide more positive front arm location during spirited driving while also will reducing inner tire wear* due to toe deflection under braking.  Do not be alarmed by the durometer of these bushings, you will not experience any noticeable increase in harshness. 

Set includes 2-Bushing sets to replace both bushings 

INSTALLED INTO NEW FIGS Billet Machined brackets

Now Grey Anodized and updated hex design

With hundreds of these bushings installed and in service we are confident this is the best solution for dynamic toe and vehicle stability, not to mention inner tread life.

 

Fits:

2001-2006 LS430 (must remove teardrop factory taper washer)

2006+ IS Vehicles

2006+ GS vehicles

2015+ RC-F

2016+ GS-F

2015+ RC350



includes grease

no shop press required since we include the brackets, just bolt-in.

 Video of it in action


Install:

The bushing sits at the back of the front LCA which is held on by two bolts into the chassis and one nut that is threaded on to an extension of the arm.

You will need to remove both under-covers and the side bracket bolt that is attached to the #2 bushing bracket.

Remove the two bolts holding the bushing bracket (one with nut) and 2 side rail bracket 

Remove the rear nut that holds the bracket to the LCA.

Remove rear bushing bracket, this may require deflection of the front arm bushing or unbolting the front location to free preload   If too difficult you will need to remove the entire arm, sway bar and shock absorber. Contact FIGS is this is the case.

Install new bushings making sure the bevel on the bushing tube is oriented towards the front of the vehicle.

Reinstall rear nut to hold bushing in place but not to final torque. 

Reinstall 2 bolts plus nut  and 2 bolts of side bracket.   Long bolt through side rail bracket torque to 204Nm/ 150ft-lbs, short bolt with nut 86Nm/63ft-lbs, and the side rail bolts 50Nm/37ft-lbs. Apply final torque to the nut at the center of of the bushing 113Nm/ 83ft-lbs.

Verify clean cycling of the suspension by loading and unloading.  If any other OE or rubber bushings where loosened or replaced, load the suspension and then final torque them to prevent their premature wear. 

You done!


*Alignment is still required to benefit from tire wear reduction. 

Lexus RC350 2015-2023
Lexus RC300 2016-2023
Lexus RC200t 2016-2017
Lexus RC F 2015-2023
Lexus LS430 2001-2006
Lexus IS500 2022-2024
Lexus IS350 2006-2024
Lexus IS300 2016-2024
Lexus IS250 2006-2015
Lexus IS200t 2016-2017
Lexus IS F 2008-2014
Lexus GS460 2008-2011
Lexus GS450h 2013-2018
Lexus GS430 2006-2007
Lexus GS350 2013-2020

Write a review

Please login or register to review

FRONT LOWER ARM REAR MOUNT #2 POLYURETHANE BUSHING 90 HIGH PERFORMANCE INSTALLED IN BRACKET

  • $360.00


Related Products

FIGS STREET SPEC MEGA ARMS GEN 2 IS / IS-F  V2

FIGS STREET SPEC MEGA ARMS GEN 2 IS / IS-F V2

TECH DATA CNC machined 1018 steel end fittings. Formed steel construction. Flat sections dimp..

$964.69

FIGS MEGA ARM GEN2 IS/IS-F GEN3 GS ESSENTIAL KIT FOR LOWERING

FIGS MEGA ARM GEN2 IS/IS-F GEN3 GS ESSENTIAL KIT FOR LOWERING

Making Lowering Simple The impact of lowering a second-gen IS or 3rd gen GS is dramatic. Camber, t..

$1,308.12 $1,438.93

SPC MASTER BUSHING INSTALL TOOL KIT

SPC MASTER BUSHING INSTALL TOOL KIT

Includes cups and threads to drive in just about any bushing imaginable.  We found it a great asset ..

$720.00 $1,355.73

LEXUS IS GS TRACK SPEC FRONT UPPER CONTROL ARM

LEXUS IS GS TRACK SPEC FRONT UPPER CONTROL ARM

To complement our other link and arm offerings, the IS-F product category gets a new adjustable uppe..

$909.56 $937.13

3GS 2IS/ISF REAR TRACTION LINK KNUCKLE MOUNT POLYURETHANE BUSHING

3GS 2IS/ISF REAR TRACTION LINK KNUCKLE MOUNT POLYURETHANE BUSHING

These bushings replace the staked rubber bushings on the knuckle-side mount of the rear traction lin..

$111.16

RCF GSF BC RACING DS SERIES TRUE COILOVERS

RCF GSF BC RACING DS SERIES TRUE COILOVERS

As seen on Ahmad Daham's Drift RCF, a true Coilover conversion from divorced spring and coil when st..

$1,395.00 $1,445.00

ISF/GSF/RCF HIGH HP REAR DIFF COMPLETE MOUNT KIT

ISF/GSF/RCF HIGH HP REAR DIFF COMPLETE MOUNT KIT

This is a complete rear differential mount kit for higher HP ISF/GSF/RCF.  The pinion mounts ar..

$362.98 $392.22

GEN 4 GS FRONT LOWER ARM REAR MOUNT #2 POLYURETHANE BUSHING

GEN 4 GS FRONT LOWER ARM REAR MOUNT #2 POLYURETHANE BUSHING

The outside diameter of these bushings is 85mm, if your bushing are the smaller 77mm you need to ord..

$151.18 $167.98

FIGS PROANGLE STEERING KIT FOR THE LEXUS RCF RC ISF

FIGS PROANGLE STEERING KIT FOR THE LEXUS RCF RC ISF

Tested for the last 2 years on top international drivers Ahmad Daham and Andrew Gray and these kits ..

$6,008.63

2-PIECE FRONT BRAKE ROTORS 2ND GEN IS / 3RD GEN GS

2-PIECE FRONT BRAKE ROTORS 2ND GEN IS / 3RD GEN GS

FIGS and RacingBrake have co-developed another 2-piece OEM replacement rotor for multiple Lexus vehi..

$1,025.00 $1,100.00

RB 4/2 POT CALIPER KIT (330x30/330x24) GEN2 IS GEN3 GS

RB 4/2 POT CALIPER KIT (330x30/330x24) GEN2 IS GEN3 GS

FIGS and RacingBrake have co-developed another 2-piece OEM replacement rotor for multiple Lexus vehi..

$3,610.00 $4,000.00

RB 2-PIECE ROTOR KIT (380x34/342x28) GSF AND RCF

RB 2-PIECE ROTOR KIT (380x34/342x28) GSF AND RCF

A 2-Piece Rotor Kit for the RC-F or GS-F.Includes front and rear rotors with XT910 pads...

$2,926.00 $3,080.00

4 POT CALIPER 2-PIECE FRONT BRAKE ROTORS 2ND GEN IS / 3RD GEN GS

4 POT CALIPER 2-PIECE FRONT BRAKE ROTORS 2ND GEN IS / 3RD GEN GS

FIGS and RacingBrake have co-developed another 2-piece OEM replacement rotor for multiple Lexus vehi..

$2,080.45 $2,211.00

FIGS TRACK SPEC MEGA ARMS GEN 2 IS / IS-F  V2

FIGS TRACK SPEC MEGA ARMS GEN 2 IS / IS-F V2

TECH DATA CNC machined 1018 steel end fittings. Formed steel construction. Flat sections dimp..

$1,080.19

RB 2-PIECE REPLACEMENT FRONT ROTORS GSF AND RCF

RB 2-PIECE REPLACEMENT FRONT ROTORS GSF AND RCF

Meant for use with the following brake kits.https://shopfigs.com/v5/LX-IRK-02https://shopfigs.com/v5..

$764.42

RB 6/4 POT CALIPER KIT (380x32/360x26) IS500

RB 6/4 POT CALIPER KIT (380x32/360x26) IS500

The IS500 6-piston front and 4-piston rear caliper kit is a high-performance braking system designed..

$6,000.00 $6,479.00

Tags: 48075-30030, 48075-30050, 3491, 2006+, is350, is250, isf, rcf, rc350, fsport, ls430, gs450h, gs350, rcf, gsf, RC-F, GS-F, is 350, is 250, is f, rc f, rc 350, f sport, ls 430, gs 450h, gs 350, gs f, IS-F, Front, Lower, Arm, Rear, Mount, #2, 3491, bracket