A component is out of stock to assemble so expecting to have parts to finish assembly of these Mid-November.
Upper arms that pull in the top and place the ball joint as close to the airbag as possible. Designed to require minimal chassis fin modification, these arms allow up to -8 degrees of negative camber
Steel plate construction with specific gusseting for structure and clearance.
Inner MOTO rod end for static offset adjustment. Dial in airbag clearance with this adjustment, dismount required..
Sliding ball joint carrier for outer fine camber adjustment without arm removal.
3-piece precision bearing ball joint and Chromoly steel taper stud. Locking washers and bolts for ball joint adjustment.
Standard FIGS powder coat included.
SUS 303 spacers for inner mount.
remove factory arm and ball joint.
Install new FIGS arm onto 2 body mounts, cycle arm without connecting to spindle to check for clearance. Trim as required.
Adjust rod ends such that arm clears coilovers or airbag.
Install ball joint into the spindle and tighten to factory specifications.
Adjust sliding ball joint carrier to desired settings and secure 3 M8 bolts with 20ft-lbs of torque. Ensure serrated locking washers are installed.
Due to the extreme nature of VIP suspension components it is strongly suggested to have components professionally installed and adjusted. All liability related to use will fall on the end customer, parts are provided for show vehicle use. On-road driving at owner' risk.
***PLEASE ALLOW UP TO 3-WEEKS for FABRICATION***
We typically fabricate / powdercoat / ship within a week depending on our overall shop load. Please contact us with questions you might have or if have a tight turn around schedule.