A BEST SELLER!!

Ask Question

Born of necessity, we set out to resolve the destructive impact of jacking on the factory jack points.  Our IS-F had been punished by repeated jacking at the weak factory seams and even with extensive repair at the body shop they were never the same.  So how could we prevent this in the future, the Jack Jaw was born.  The resulting product was created after extensive testing and long term abuse at the track and on the lift.  We feel it’s a simple elegant solution to get you jacking with confidence again.  Keep 2 in the car when you take it in for service, one in the track bag for the wheel changes and one on the mantle.

 

Your order includes:

1 FIGS Jack Jack adapter

 

Features

-6061 Aluminum extrusion

-Urethane insulator liner to protect paint and center the JACK JAW for alignment.

-1.5" profile will reach behind side skirts and other aero parts keeping your jack's support beam from harming them.

-Transparent Orange Powdercoated aluminum end caps for long lasting looks and high visibility.  Also serves as a ridgid gusset for strength. 

-Gap is approx 7mm with no insulator and 2.5mm with insulator.  If your frame fits this range then the product should work universally however it has only been tested on Lexus vehicles and a few German makes.  Remove insulator only if rail is damged or wider than 2.5mm.


If you have a fresh jack point ALWAYS USE THE INSULATOR to prevent the jack jack from rocking.  If the load shifts from the center channel it will damage the jack jaw. If at any point there is concern please contact us.

 

To Install:

-Slip over frame rail factory jacking point

-Make sure rail bottoms into the valley of the Jack Jaw

-Lube Urethane for easier sliding.

-Jack at base of Jack Jaw in the center of the circular jack pad.

   

 

Demonstration video 

FIGS JACK JAW instructional Video One from FIGS Engineering on Vimeo.

from FIGS Engineering on Vimeo.

 

NOTICE: Weight is supported in the center of the channel not the top of the block. If for any reason this is not the case during installation please contact FIGS for a shim kit.  

NEVER Use on a jack stand or a jack that does not support the entire length of the Jack Jaw block.

Write a review

Please login or register to review

FIGS JACK JAW FRAME RAIL ARMOR

  • $38.59


Related Products

322MMX25 2-PIECE ROTOR FRONT BBK FR-S BRZ

322MMX25 2-PIECE ROTOR FRONT BBK FR-S BRZ

We are pleased to finally announce our 2-Piece Rotor 4-Pot Front BBK for the FR-S, BRZ and GT86. ..

$1,570.00 $1,772.22

Tags: jack jaw, jackjaw, jack point, jack, frame, armor